SoftGate PRO Installation¶
Minimum Hardware Requirements¶
2 x Intel® Xeon® Silver Processor with 10 physical cores per socket (20 cores total)
128 GB (64 GB RAM per socket) in multichannel configuration
300 GB HDD
Nvidia Mellanox Connect-X 5/6 SmartNIC card
The following are some recommendations for BIOS settings. Different vendors will have different BIOS naming so the following is mainly for reference:
Before starting consider resetting all BIOS settings to their defaults
Disable all power saving options such as: Power performance tuning, CPU P-State, CPU C3 Report and CPU C6 Report
Select Performance as the CPU Power and Performance policy
Enable Turbo Boost
Set memory frequency to the highest available number, NOT auto
Disable all virtualization options when you test the physical function of the NIC, and turn off VT-d
Install the Netris Agent¶
Requires freshly installed Ubuntu Linux 18.04 LTS and internet connectivity configured from netplan via management port.
Add the SoftGate in the controller Inventory or Topology section. Detailed configuration documentation is available here: “Adding SoftGates”.
Once the SoftGate is created, navigate to the Inventory section, click the three vertical dots (⋮) on the right side of the newly created SoftGate and select the Install Agent option.
Copy the agent install line to your clipboard and run it on the SoftGate as an ordinary user.
When the installation is complete, review the ifupdown configuration file and verify that the presented configuration corresponds to what you configured during OS installation (the file is generated based on your initial netplan configuration).
If the Netris Controller is not in the same OOB network then add a route to Netris Controller. No default route or other IP addresses should be configured.
[email protected]:~$ sudo vim /etc/network/interfaces
# The loopback network interface auto lo iface lo inet loopback # The management network interface auto ensZ iface ensZ inet static address <Management IP address/prefix length> up ip route add <Controller address> via <Management network gateway> # Please delete this line if Netris Controller is located in the same network with the SoftGate node. gateway <Gateway IP address> source /etc/network/interfaces.d/*
If everything seems ok, please remove/comment the Gateway line and save the file.
Please do not configure any additional IP addresses other than those described in the example above. The further configuration will be performed by the Netris agent.
Reboot the SoftGate
[email protected]:~$ sudo reboot
Once the server boots up you should see its heartbeat going from Critical to OK in Net→Inventory, Telescope→Dashboard, and the SoftGate color will reflect its health in Net→Topology.